Cross Technologies 2582-122, Instruction Manual

Page: 9 / 16

2.2 Rear Panel Input/Output Signals
Figure 2.1 shows the input and output connectors on the rear panel.
AC 1
TOP - ONLINE 1- J51
AC 2
BOT - ONLINE 2- J52
TOP - BACK UP- J55
BOT - SWITCH- J56
CH2 CH1 BU
J11 J12 J21 J22 J1 J2
J13 J14 J23 J24 J3 J4
IF
RF
IF
RF
CONV
IN/OUT CONV IN/OUT CONV IN/OUT
AC1, AC2 - POWER IN
AC inputs for redundant
switching power supplies.
100-240 ±10% VAC, 47-60 Hz.
SWITCH M&C (J56)
Monitor and controls for the
2582 switch.
CH1 and CH2 M&C (J51, J52)
Monitor and controls for Unit #1
and Unit #2.
BACK UP M&C (J55)
Monitor and controls for
the Back-Up unit.
IF SIGNALS (J13, J14, J23, J24, J3, J4)
Signals to/from Unit #1, Unit #2 and the Backup Unit
CONV goes to the up/down converter
IN/OUT is the input to or the output from the converter.
BNC (female) 75
Ω .
RF SIGNALS (J11, J12, J21, J22, J1, J2)
Signals to/from Unit #1, Unit #2 and the Backup Unit
CONV goes to the up/down converter
IN/OUT is the input to or the output from the converter.
BNC (female) 75
Ω .
J11 J15
J13
A
B
A
B
GND
ETHERNET
FIGURE 2.1 2582-122 Rear Panel I/O ʼ s
TABLE 2.1 SWITCH Pinouts (RS-232C/422/485) TABLE 2.1 SWITCH Pinouts (RS-232C/422/485)
Pin Function
1 Rx-
2 Rx+ (RS-232C)
3 Tx+ (RS-232C)
4 Tx-
5 GND
6 Alarm Relay: Common
7 Alarm Relay: Normally Open
8 Not Used
9 Alarm Relay: Normally Closed
*Remote Serial Interface
Interface: DB-9 Male
Protocol: RS-232C/422/485, 9600 baud rate, no parity,
8 data bits, 1 start bit, 1 stop bit.
2582-122 Manual, Rev. B Page 9 1/24/22
TABLE 2.2 CH1,CH2,BU Pinouts TABLE 2.2 CH1,CH2,BU Pinouts
Pin Function
1 Tx-
2 Tx+ (RS-232C)
3 Rx+ (RS-232C)
4 Rx-
5 GND
6 Alarm Relay: Common
7 Alarm Relay: Normally Open
8 Not Used
9 Alarm Relay: Normally Closed