2.4 Accessing the PC Card
There are NO USER JUMPERS or other on-card controls. ALTHOUGH IT IS NOT RECOMMENDED AND
MAY VOID THE WARRANTY the following explains how to remove the printed circuit board (PCB) from the
extrusion:
1. Always remove power when installing or removing the PCB from the extrusion
2. Remove four (4) rear panel screws (see Figure 2.3).
3. Gently pull the rear panel and PCB assembly completely out of the extrusion.
4. To install the PCB gently push the rear panel and PCB assembly completely into the extrusion Make
sure the shield goes in the lower channel and the PCB in the next channel above that in the extrusion and
that the front panel controls go through the front panel holes.
5. Install four (4) rear panel screws.
EXTRUSION
FRONT SCREWS (4EA)
FRONT PANEL
RACK MOUNT PANEL (FOR -R MODELS ONLY)
REAR SCREWS (4EA)
PCB ASSEMBLY
REAR PANEL
WALL
POWER
SUPPLY
2005 TEST UPCONVERTER
C
ROSS
T
ECHNOLOGIES, INC.
DC
100MHz
FREQUENCY
10MHz
1MHz
GHz
LO
IF
C K U
70 140
ALARM
(-P and -P4 MODELS)
FIGURE 2.3 2005 Assembly Drawing
2005-02/03 Manual, Rev. J
Page 6
08/14/2019
