Auxiliary Inputs
There is no power
1
Make sure radio is plugged in correctly.
2
Look at the STAND BY INDICATOR and check
to see if it is red.
3
If the red light is on, press the
POWER
/
to
turn the unit on.
There is no sound
1
Make sure the mute function is turned off.
2
Check that the volume is turned up by pressing
VOLUME UP
/
on the remote.
Note:
Volume range on some units start at level
15 and ends at level 40.
3. Make sure INT./EXT. switch on back of radio is
switched to INT. (Unless you are using external
speakers, in which case it should be on EXT. )
4
Check to make sure power is turned on.
CD does not play
1
Check to make sure CD is inserted correctly
(label side facing up).
2
Check to see that surface of CD is clean.
3
Make sure function switch is set to CD mode.
Remote not working
1
Replace battery.
2
Be sure to point the remote towards remote
sensor when operating.
3
Remove obstacles in the path of the remote and
radio so the remote signal has a straight path
to the radio.
General
TROUBLESHOOTING
1 With your new radio, you have the option of
adding external speakers.
2 The speaker jacks for external speakers are
located on the back of the radio. Along with the
speaker jacks is a switch labeled Int./Ext.
When using external speakers, this switch must
be switched to the EXT. position. Doing this turns
off the internal speakers in the radio and redirects
the power to the external speakers.
3 If you decide not to use the external speakers,
be sure the switch is switch to INT.
OPTIONAL EXTERNAL SPEAKERS
LED LIGHTING
The 7-colour changing LED lights in the front tubes
are controlled by the LIGHTING SWITCH
(RELEASE/HOLD) on the rear of the unit.
Using the Aux Input allows you to hook up additional
external audio components and listen to them through
your unit. Any component with an audio output such
as a Tuner, can be connected by using the correct
cables . This unit uses standard RCA cables. Simply
plug the red and white connectors on one end of
the cable to the red and white RCA In jacks on the
back of your unit. The other end of the cable will
plug into the Audio Output jack on the external
component. For more information on hooking up the
external component, see the owner's manual for
that component.
13
