27
To restore service:
1
Reconnect the water, drain, and electrical power.
3
Place a pan under the inlet valve, then disconnect water line from the inlet
valve and drain it into a pan.
4
Disconnect drain line from pump and drain the water into a pan.
2
Turn on water and electrical power supply.
3
Fill the detergent cup and the rinse aid cup and run the dishwasher through
a heated-wash cycle.
4
Check all connections to make sure they do not leak.
Troubleshooting
Refer to this table to correct minor issues before calling for service.
Error codes
CODE MEANING
Solution
E1
Not enough
water flow in
allotted time
Faucet is not opened
Water pressure is too low
The drain hose is plugged
E4
Overflow or
leak sensor
activated.
A leak or too much water
in the tub.
Ed
When the display board
canʼt receive or the main
board canʼt send signal
over 20 seconds, the
dishwasher will warning
for Ed.
Caution
If an overflow occurs, turn off the main water supply before calling
for service.
If there is water in the base pan because of an overfill or small leak,
the water should be removed before restarting the dishwasher.
•
•
•
•
•
POSSIBLE CAUSE
• Confirm water is turned on to the dishwasher.
Verify the water pressure (20-80 psi).
Check the drain hose.
Communication
exception
Contact Customer Service.
• Turn off water to the dishwasher.
• Check filter system for blockage.
• If there is no water in the tub, contact
Customer Service.
•
•
•
