Sewing cords
Sewing zippers
38
Presser foot . . . . . . . . . . . . . . . . . . . . . .zipper foot
Program selection . . . . . . . . . . . . . . . . . . . . . . . . . .1
Stitch length dial . . . . . . . . . . . . . . . . . . . . . . . .1 - 4
3. With the zipper foot you can also easily sew
cords, as shown in the figure next hereto.
2
1
C
B
3
Attention!
Before the foot reaches the slide of the zipper, raise the foot and open the zipper, while
leaving the needle in the material (C).
Teeth
Slide
Cord
Groove
Groove
A
Raise the presser foot (14) and the needle to
their highest position. Remove the presser foot
and attach the zipper foot in its place.
1. Instructions for removing and inserting the
presser foot can be found on page 9.
Caution! The zipper foot is either attached
from the left or from the right side and not in
the middle as all other presser foots.
2. Baste the zipper to the fabric and place the
material in the right position under
the foot.
For sewing the right side of the zipper,
bring the zipper foot into position
so that the needle will sew on the
left side (A).
When sewing on the right side of the
zipper, the seam should be stitched
as close as possible to the teeth (A).
For sewing the left side of the zipper,
change the foot position at the presser
foot holder (16).
Proceed in the same way as on the
right side of the zipper (B).
Band
Teeth
Slide
