CROC TPS20, Product Manual, Page: 10 / 16

10 | CROC Trough Pump Systems ‘TPS20
TM
Product Manual’
TPS20
TM
PRODUCT MANUAL
Notes:
• The power cable is protected by metal spiral
convoluted tube. This tube must be securely
attached to the pole supporting the solar
panel, with tube saddles provided. The power
cable can also be ran down inside the metal
tube to the height of the trough
• The solar panel should be cleaned regularly in
all conditions. A damp cloth or window washer/
squeegee is recommended.
• Trough standing water level should always be
at least 100m to 150mm below the top edge of
the water trough.
• Trough water level should be adjusted if water
from the pump is being blown out
of the trough by the wind.
• Please refer to the Croc-TPS website
for photos of different ways to install
the Croc-TPS.
• The solar panel is fitted with a red light
to indicate the solar panel is operational,
but it does not indicate the amount of
power the solar panel is generating.
• The Croc-TPS is not a trough cleaning device.
The filter is fitted to protect the pump from
becoming blocked and causing damage to
the pump.
• The solar panel must be installed on a strong
wooden or steel post, out of the reach of
the animals being watered, so there is no
interference with the solar panel and its parts.
• Pump filter should be cleaned regularly
depending on the situation. A coarse
laundry brush is recommended.
• The trough should be cleaned thoroughly
before installing the pump system.
• If algae is present, it is recommended to treat
the trough with an Algaecide to kill the algae
cells present in the trough.
• Animals are very inquisitive; they will tamper
with and chew on any loose materials when
bored. So, it is imperative that pump and cable
are secured and protected from all animals.
• The TPS has been trialled in many
different trough designs/types.
We can only recommend a basic
installation and protection method.
Please visit croctroughpumps.com
for ideas to assist with your installation.