Visit us at
crlaurence.com
for international toll free information 8
A
C.R. LAURENCE Co., INC.
OPERATION
Speed Control
You can increase the rotation speed by pushing
the speed button forward. Position 2: 0-1150min
-1
You can decrease the rotation speed by pushing
the speed button to the rear. Position 1: 0-400min
-1
High Speed
Low Speed
Varying the Speed
Simply apply pressure onto the On-Off Switch by squeezing it. This will increase the speed.
Releasing pressure on the On-Off Switch will decrease the speed.
Torque Adjustments
This relates to the tightening power of your
drill/driver. Depending on the application,
various levels of driving power are required.
Generally the larger the screw diameter the
higher the torque power required to drive the
screw until it is properly seated.
1 to 2:
For driving small screws.
3 to 4:
For driving screws into soft materials
or plastics.
5 to 7:
For driving screws into soft woods.
11 to 14: For driving screws into medium/hard woods.
15 to 16: For powerful screw driving or drilling metal
or using spade/hole bits.
17-Stage Torque Setter
1
CAUTION: Always start on the lowest setting. If the correct setting has been chosen, an override
clutch opens once the screw has been turned flush into the material. When removing screws,
select a higher setting or set to drill symbol. The proper settings are best determined in practice trials.
When drilling into metal, if possible, punch the drilling position first so as to prevent drill-bit run away.
Use a suitable coolant. Ask your dealer about particular applications.
The appliance's noise output may exceed 85dB (1) at the workplace. In this instance, wear ear protection.
Maintenance/Cleaning
Before doing any work on the machine itself, remove the battery packet. Clean the tool with a moist cloth
and a little lubricating soap. Do not use any cleaning agents or solvents. These could attack the plastic
parts of the appliance. Always keep the surface of the device free from dust and dirt.
1
