I
II
III
CALL
V
ANTENNA
LCD
PANEL
PAGE/
CALL
SILENT
LOW
BATT
CAR
ICON
ENGINE
BUTTONS 1,2,3
RUN
FM
Two-way
LED
CLOCK/TEXT
ICONS
OPERATION
PAGER / REMOTE TRANSCEIVER:
The hand-held remote transceiver is used to send commands to and
receive information from the vehicle. The Control Module transmits
High Frequency FM signals to the pager for various alarm functions
up to a ½ mile away. Your range will vary depending on location,
terrain, and local RF noise/interference. This system is not
guaranteed to page you if you are behind concrete walls,
underground, in a large structure, or in an area with high electronic
interference. Handle the pager/remote with care as the LCD display
and/or the electronics may be damaged if abused. You may pull up
the built-in antenna for additional range. Push the antenna in for
storage in your pocket or purse. The transceiver uses a standard
AAA Alkaline Cell battery that can easily be replaced by sliding open
the battery access door on the back of the unit. Battery life will vary
depending on usage.
BUTTON (I):
•
Press and release to Arm/Disarm system.
•
Press and Hold for Panic feature.
BUTTON (II):
•
Press and Hold for more than 1 second for Remote Engine
Start/Stop
•
Press and release to activate Blue LCD screen back lighting or
cancel a confirmation tone.
BUTTON (III):
•
Press and Hold for trunk pop or auxiliary output.
•
Press and release to confirm status of system. Remote will query the unit in the vehicle and display the current
status of arm, disarm, or engine run.
ARMING:
Press the (I) button on the transceiver to arm the system. The LCD Display will read “ARM”, the “LOCK” icon will
appear, and the remote will emit a 3-beep audible signal. At the vehicle, the siren will chirp once and the lights will
flash once. The red LED in the vehicle will start flashing. The system will arm, lock the doors, and the starter will be
disabled if these optional features are installed).
