“HANDS FREE” REMOTE CONTROL (OPTIONAL)
This 2008PC system is compatible with an optional “Hands-free” remote transmitters (not included in kit). The
“Hands-free” remote transmitter adds two important features.
•
Convenient “hands-free” operation and additional security.
•
Additional Security: When using the hands free remote, the alarm will operate normally, but starting the
vehicle is enabled ONLY if the hands free remote is detected. Keeping the Hands-free remote
separate from the key chain will help prevent a vehicle theft even if the keys & remote have been
stolen.
How Hands-Free Mode Works:
3 Seconds
ON/OFF/TRANSMIT
Button
Pulses every
LED
HANDS-FREE TRANSMITTER
As you turn your Ignition OFF and
leave your vehicle, the system will
automatically arm. The tiny hands-
free remote transmitter emits a low
power signal every few seconds. As
you return to your vehicle
(approximately within 15-30 feet), the
system will receive the signal from
the remote and disarm/unlock your
vehicle. To operate in hands-free
mode, the remote transmitter must
be turned ON.
Turning the Remote ON (Start
sending signals):
Press and hold the remote button for about 5 seconds until LED on remote flashes once (Ignore first double
flash). The remote is now ON and will send a signal every few seconds. If you remain near your vehicle with
the remote arm is will never arm. (Note: The remote is OFF when this system is shipped from the factory to
save battery life.)
Arming:
When exiting the vehicle, (Ignition turned off) there will be a 15-second delay before the system
AUTOMATICALLY arms. Again if your remote is turned on and you are within range your vehicle may not arm
because it is receiving signal from the remote. After the delay, the system will arm. NOTE: If your remain in or
near your vehicle, the system will not arm because it is receiving signals from the hands-free transmitter.
Disarming: (Hands Free Mode)
As you return to your vehicle (approximately within 15-30 feet), the alarm system will receive the signal from
the tiny remote and disarm/unlock your vehicle.
Manual Arming/Disarming:
If desired, this system can be armed and disarmed by pressing the button on the remote. YOU MUST HAVE
THE REMOTE OFF WHEN MANUALLY ARMING AND DISARMING. When exiting the vehicle, (Ignition
turned off) there will be a 15-second delay before the system AUTOMATICALLY arms or you can arm it by
pressing the button on the remote before the 15 second countdown ends. When returning to your vehicle
press the button on your remote to disarm.
Turning the Remote OFF (Stop sending signals):
Press and hold the remote button for 5 seconds until LED on remote flashes twice (Ignore first single flash).
The remote is now OFF and will not send signals. When you are going to be away from your vehicle for
extended periods of time, it is advisable to turn the remote off to save its battery life. However before you
return to your car, you must re-activate the remote or press the button using it manually.
Remote Status: ON or OFF? (How to check it):
Press the button on the remote and observe the LED. If it flashes ONCE, then it is on, or if the remote flashes
TWICE it is OFF. You can perform this simple check at anytime to check the status of the remote.
Summary of Contents for SecurLinc CS-2008PC
Page 5: ...SYSTEM WIRING DIAGRAM 1...
Page 6: ...SYSTEM WIRING DIAGRAM 2...
