1
WIRING INSTRUCTIONS
PROGRAM/OVERRIDE SWITCH: 2 PIN PLUG
This switch is used primarily for programming features of the RS900/901. However, if the Anti-Grind/Starter disable
feature is installed, you MUST INSTALL this switch. This switch will allow the user to override the starter disable in
the event of a non-operating remote control.
LED: 2 PIN PLUG
The LED is only used as a VALET/PROGRAMMING indicator. The LED comes on solid when the unit is in valet or
programming mode. The LED is not a mandatory installation item.
12 PIN PLUG:
PIN 1: YELLOW: (-) IGNITION 1 OUTPUT (FOR RELAY)
PIN 2: YELLOW/WHITE: (-) IGN2/ACC OUTPUT (FOR RELAY)
Use these wires when the vehicle requires a second IGNITION 1, IGNITION 2, or ACCESSORY wire to be
activated. This occurs commonly in Toyota, and late model GM cars. See diagram below:
PIN 3: BLACK: MAIN SYSTEM GROUND
Connect to chassis metal of the vehicle. An existing bolt or screw MAY provide an adequate ground, or drill a small
hole, scrape away paint and attach using a sheet metal screw & star washer. If this wire is not connected OR
connected to a point on the vehicle that provides a poor ground, undesirable and inconsistent operation will occur.
YELLOW
85
86
INSERT DIODE AS SHOWN
+
-
30
87
BATTERY
2nd IGN 1
(YELLOW/WHITE)
OR
(2nd IGN2 /ACC WITH YEL/WHT)
OR
Summary of Contents for RS-900ER.II
Page 9: ...7...
