TRANSMITTER PROGRAMMING
Transmitter Code Learning: (Excludes RS901)
Note: All transmitter codes must be learned at time of programming!! The RS900 allows storage of up to 4
different transmitter codes.
1. Open Hood. (Ground Gray wire.)
2. Turn key to the ON position. (Doors will lock if Autolock is programmed)
3. Press Programming button 4 times, then after a few seconds the unit will flash the parking lights 4 times.
4. Press button #1 of the transmitter to be coded. You should get light flashes with each code learned. If all 4 code
locations are learned, the unit will automatically exit code learning mode, otherwise turn key off and close hood.
OPTION PROGRAMMING
This system has several installer programmable features. See chart below for features.
Options Programming:
1. Open hood
2. Turn Key to the ON position
3. Press program button 5 times, after a few seconds the unit will flash the lights 5 times.
4. Slowly push the program button the number of times that corresponds to the option number desired. You
should get a light flash after each button press.
5.
When you reach the desired programming level, Press button #1(LOCK) on the transmitter to change the
option from the factory default or Press button #2 (UNLOCK) to return the option back to default (except for
the Run Time option.) See chart below.
PROGRAMMING OPTIONS CHART
Option #
Option Description
Option Values
Fac. Pre-set
1
Autolock with Ignition
On or Off.
ON
2
Door Lock Pulse Time
.075 or 3.0 sec.
.075
3
Double Unlock Pulse
On or Off
OFF
4
Tach Learning
N/A
N/A
5
Remote Start Run Time
Button #1 = 12 min.
Button #2 = 24 min.
Button #3 = 36 min.
Button #4 = 48 min.
24 min
6
Option reset
Button #2
N/A
Summary of Contents for RS-900ER.II
Page 9: ...7...
