STARTER DISABLE WIRING
STARTER DISABLE PLUG: 3 ORANGE 14 GA. WIRES:
(Normally Closed or Normally Open Configuration with ON-Board Relay)
Note: read the following configuration options before connecting starter disable!
Normally Closed Starter disable
is the standard type used with most alarm systems today. This circuit will disable
the Starter while the alarm is armed or has been triggered. If 12V power is removed from the system, the Battery goes
dead, or the alarm is removed for service the vehicle will start normally as if no alarm were installed. (Factory Default)
Normally Open Starter Disable
is a High-Security circuit that will disable the starter while the alarm is armed or
triggered AND if the unit is unplugged or removed from power. This means that if the vehicle’s Battery goes dead or
the unit is unplugged from the vehicle, the car will still not start. We only recommend this type of circuit if you can
install a hidden high-current toggle switch to defeat the Normally Open disable in case of a dead battery or if the unit is
unplugged/remove for service. (Toggle not included)
CUT
START WIRE
STARTER
ORANGE
IGN
SWITCH
ORANGE
ORANGE
N/C
N/O
COM
NOTE ALIGNMENT OF PLUG
N/C = NORMALLY CLOSED
NORMALLY CLOSED STARTER DISABLE (DEFAULT)
CUT
START WIRE
STARTER
ORANGE
IGN
SWITCH
ORANGE
ORANGE
N/C
N/O
COM
NOTE ALIGNMENT OF PLUG
N/O = NORMALLY OPEN
HIDDEN TOGGLE
SWITCH
**JUMPER #7 MUST BE
REMOVED!**
(NOT INCLUDED)
NORMALLY OPEN STARTER DISABLE (OPTIONAL)
Summary of Contents for CS-2004 WDC
Page 17: ......
