Crestron
TSW-730-MSMK
Multi-Surface Mount Kit for TSW-730
Installation Guide – DOC. 7415A
Multi-Surface Mount Kit for TSW-730: TSW-730-MSMK
•
5
Installation
This section provides an installation procedure for each mounting scenario. “Glass
Mounting” starts below, “Drywall, Paneling, Concrete or Brick Mounting” starts on
page 12 and “Raceway Mounting” is on page 15. Be sure to review each procedure
before starting.
Glass Mounting
The touch screen can be mounted onto a flat pane of glass or similar smooth surface
(such as granite, marble, plaster, smooth stone or masonry) using the included glass
mounting plate. The back of the plate has an adhesive tape that permanently attaches
to the glass. The touch screen can be flat mounted or angle mounted to the glass
mounting plate by following the appropriate procedure below. After installation is
complete, the raceway kit may be installed on a smooth surface by following the
“Raceway Mounting” procedure on page 15.
NOTE:
Ensure the glass mounting surface is cleaned with a glass cleaning product
that does not leave a film and is free of debris before mounting. Once glass mounting
plate has been attached, it cannot be easily removed.
Flat Mounting
Complete the following procedure to attach the glass mounting plate. The only tools
and supplies required and not supplied are a level, tape, #2 Phillips screwdriver, 1/4”
hex driver and a glass cleaning product that does not leave a film. A T8 Torx bit is
supplied with the touch screen.
1.
Thoroughly clean and dry the glass mounting surface using a glass cleaning
product that does not leave a film.
2.
Using the level, carefully tape a horizontal reference line that coincides with
the lower edge of the mounting bracket.
CAUTION: Adhesive on glass mounting plate is a high strength bond.
Once adhesive meets a surface, it cannot be easily removed or adjusted.
3.
Remove the adhesive backing from the glass mounting plate.
4.
Holding the glass mounting plate (4516855) at a 45 degree angle to the
glass, carefully align the lower edge of the mounting plate with the level
taped line. Do not allow adhesive backing to come in contact with the glass.
5.
Once aligned with the level reference line, carefully tilt the glass mounting
plate back until it is secured to the glass. Firmly press glass mounting plate
to the glass to ensure proper adhesion and that any trapped air bubbles are
removed.
6.
Using a flathead screwdriver, carefully separate the back cover of the touch
screen from the front of the unit. This part is not used. Refer to the
following illustration.
