4X4 QuickMedia™ Matrix Switcher
Crestron
QM-MD4X4
Suggested Power Connections for QM-MD4X4
QM-MD4X4
QUICKMEDIA RECEIVER/PROCESSOR
QM-RMCRX-BA
300 WATT POWER SUPPLY
C2N-SPWS300
NOTE:
The QM-MD4X4 can only be powered by the 4-position terminal block
connector labeled “NET”.
NOTE:
Cresnet data is fed through the NET connector that is internally wired to the
4-position mini-terminal block connector at each QM connector.
NOTE:
In the configuration shown, the C2N-SPWS300 can operate in the “PWR
ON” position or the “PWR OFF SLAVE” position. For more information, refer to
the latest revision of the C2N-SPWS300 System Power Supply Operations Guide
(Doc. 8190).
NOTE:
Power to the QM ports on the QM-MD4X4 can be applied using other
configurations. The total power usage of each port group must not exceed the port
group’s available input power. For example, if 75 watts is supplied to QM inputs 1
through 4, the total power consumption for those ports cannot exceed 75 watts.
Label the Buttons
Use Crestron Engraver software to print custom labels for the QM-MD4X4’s front
panel buttons and LEDS. Crestron recommends printing on 100-pound paper. Paper
weighing less than 100 pounds will tend to crumple while sliding in, while paper
weighing more than 100 pounds may not fit.
Labels can also be created using a 3/8” label maker.
16
•
4X4 QuickMedia™ Matrix Switcher: QM-MD4X4
Operations Guide – DOC. 6546A
