Crestron
QM-WMC
Wall Plate Media Center
1. The latest software versions can be obtained from the Downloads | Software
Updates section of the Crestron website (
NOTE following these footnotes.
2. Crestron 2-Series control systems include the AV2 and PRO2. Consult the
latest Crestron Product Catalog for a complete list of 2-Series control systems.
3. Longer lengths of CAT5/5E/6 cable can be used. However, the cumulative
skew must be
≤
15 ns for the entire length of cable used between all QM
devices. Longer lengths of cable may experience eventual loss of bandwidth
when viewing higher resolution sources. For more information, refer to
“QuickMedia Wiring” on page 15.
NOTE
: Crestron software and any files on the website are for Authorized
Crestron dealers and Crestron Authorized Independent Programmers
(CAIP) only. New users may be required to register to obtain access to
certain areas of the site (including the FTP site).
Physical Description
Refer to the following illustrations. The front of the QM-WMC has
connections for composite video (RCA), S-video (Mini-DIN, 4-pin), and
RGB (DB15HD) inputs as well as corresponding stereo inputs for each
video source. An additional DB15HD connector allows the hookup of an
additional monitor.
LEDs on the front of the wall plate indicate power, Cresnet activity, the
video-source(s) that are detected, and setup mode.
The rear of the QM-WMC has two mini-Cresnet connectors for
integration into a Cresnet network as well as a QuickMedia connector for
simple connection of media signals to a QuickMedia receiver. A 14-pin
connector allows for connection to the optional QM-WMIC. Refer to the
latest revision of the QM-WMIC Operations & Installation Guide (Doc.
6245) which can be downloaded from the Downloads | Product Manuals
section of the Crestron website (
).
NOTE:
Decorative faceplates, as shown in the following illustration, are
not supplied with the wall plates.
Operations & Installation Guide - DOC. 6237A
Wall Plate Media Center: QM-WMC
•
7
