Mud Mount Kits
Crestron
MMK-V12 & WMKM-V12
8. Carefully pass the adjustment/mounting plate assembly through the opening
and rest the assembly against the interior surface of the mounting surface.
Verify that the adjustment plates are between the mounting plate and the
mounting surface.
9. When the adjustment/mounting plate assembly is in position, bend the top
two flanges of the mud ring upward (approximately 90 degrees) and the
bottom two flanges downward (approximately 90 degrees). Refer to the
illustration below.
NOTE:
Adjustment/mounting plate assembly will have slight play; this is normal. It
allows for minor adjustments to the entire assembly during installation.
Bend Flanges
Bend all
four flanges
10. Use four application specific screws (length should not exceed mounting
surface thickness by more than 1/2” (13 mm)) to secure the plate to the
adjustment/mounting plate assembly. The screws pass through the clearance
holes in the mud ring plate and are secured in the extruded holes of the
adjustment plates.
11. Verify that the plate is level before tightening.
NOTE:
Do not overtighten screws. Doing so may damage the plate.
12
•
Mud Mount Kits: MMK-V12 & WMKM-V12
Installation Guide – DOC. 6892A
