Crestron
MMK-V12 & WMKM-V12
Mud Mount Kits
2. Slide a push-on fastener over each pin on the adjustment plate to loosely
secure the adjustment plate and the mounting plate. Do not push the
push-on fasteners all the way down onto the pins. Slide them on enough to
keep the adjustment plate and mounting plate as one adjustment/mounting
plate assembly.
3. Use the second adjustment plate and repeat steps 1 and 2 using the lower
two holes of the mounting plate.
4. Locate an area on the mounting surface that is free of miscellaneous wiring
and studs.
5. Make a small hole near the middle of the designated site; verify that the
location is suitable.
NOTE:
Make the cutout as clean and level as possible. The mounting plate
allows for only minor leveling adjustments.
6. Use the saw or equivalent and the provided cutout template to produce an
accurate and level cutout in the mounting surface.
7. Insert the symmetrical mud ring plate into the opening, as shown in the
illustration below.
Insert Mud Ring Plate into Opening
Mud Ring
(2025263)
Mounting
Surface
Holes for Screws (4)
(not included)
NOTE:
Screw length
should not exceed
mounting surface
thickness by more
than 1/2" (13 mm).
Installation Guide – DOC. 6892A
Mud Mount Kits: MMK-V12 & WMKM-V12
•
11
