Crestron
TPS-6
Isys™ 5.7” Tilt Touchpanel
Configuring the Touchpanel
NOTE:
The only connection required to configure the touchpanel is power. Refer to
“Hardware Hookup” which starts on page 27 for details.
To configure the TPS-6 it may be necessary to access a series of setup menus prior to
viewing run-time screens that are loaded into the touchpanel for normal operation.
The MAIN MENU is the starting point for configuring the touchpanel.
NOTE:
If no project has been loaded or if an invalid project has been loaded, the
touchpanel displays an error message and asks the user to touch the screen to enter
setup, which defaults to the MAIN MENU.
NOTE:
Trigger key functionality is not available in the setup menus.
If a project is running, the MAIN MENU can be accessed using one of two methods:
via the trigger keys on the top of the touchpanel or via Crestron Toolbox.
Via the Trigger Keys
1. Press and hold the right trigger key on the top of the touchpanel and at the
same time, touch the upper right corner of the screen.
2. Continue holding the right trigger key and touching the upper right corner
of the screen. At the same time, press and hold the left trigger key on the
top of the touchpanel. After four seconds, the panel will reset.
3. Once the screen turns black, release the left trigger key and the panel will
enter the MAIN MENU, as shown in the illustration on the following page.
4. Release the right trigger key and the touch screen.
Via Crestron Toolbox
1. Establish communication with the touchpanel (refer to “Establishing
Communication” which starts on page 38 for details).
2. Right-click on the device and select
Functions | Setup Mode…
.
3. Select
Enter Setup Mode
. The MAIN MENU will be displayed, as shown
in the illustration on the following page.
NOTE:
Select
Exit Setup Mode
to exit the setup menu.
Operations Guide – DOC. 6945A
Isys™ 5.7” Tilt Touchpanel: TPS-6
•
11
Summary of Contents for Isys TPS-6
Page 1: ...Crestron TPS 6 Isys 5 7 TiltTouchpanel Operations Guide...
Page 4: ......