Crestron HB
K-6000 & SMK-6000
Hatch Back and Swivel Mount Kits
4. Place the touchpanel face down on a padded surface to prevent damage to
the display screen.
5. Refer to the following illustration and remove the six screws from the
bottom rear of the touchpanel that correspond to the mounting holes (A) in
the metal bracket of the kit.
SMK-6000 Swivel Mount Kit Assembly Diagram
6. Place the metal bracket on the touchpanel base (mounting holes should
align, touchpanel feet should protrude through openings provided, and
standoff posts for the rear cover should point toward the touchpanel).
Secure the metal bracket to the touchpanel using the six screws removed in
step 5.
7. Route the cables from the interface box up through the Metal Plate, through
the mounting surface, and through the Swivel Assembly, then through the
area of the bracket shown in the figure, and connect to the appropriate
touchpanel ports. Route the cables carefully to avoid chafing.
8. Being careful to avoid damage to the cables, attach the Swivel Assembly to
the Metal Bracket, using the supplied four #6-32 X 1/4 inch screws
B
through the holes in the swivel assembly into the standoff posts on the
bracket. Make certain the cables are not twisted or crimped and have
sufficient slack at the port connections before fully tightening the screws.
Installation Guide – DOC. 6111
Hatchback and Swivel Mount Kits: HBK-6000 & SMK-6000
•
3
