Hatch Back and Swivel Mount Kits
Crestron HB
K-6000 & SMK-6000
Installation
This section provides an installation procedure for each kit. The only tools required
are #1, #2, and #3 Phillips screwdrivers.
HBK-6000 Assembly/Installation Procedure
To attach the HBK-6000 Hatch Back Kit to the TPS-4500, -5000, or -6000
Touchpanel, refer to the illustration below and perform the procedures that follow.
HBK-6000 Assembly View
Metal Bracket
Plastic Cover
Mounting Holes (4)
A
A
Openings For
Touchpanel
Rear Feet (2)
Screws (4)
1. If necessary, use the touchpanel position lock buttons to adjust the display
to the maximum (most vertical/upright) angle.
2. Place the touchpanel face down on a padded surface to prevent damage to
the display screen.
3. Remove the four screws from the bottom rear of the touchpanel that
correspond to the mounting holes (A) in the metal bracket.
4. Position the metal bracket on the touchpanel base (mounting holes should
align, touchpanel feet should protrude through openings provided, and
standoff posts should point toward the touchpanel). Secure the metal
bracket to the touchpanel using the four screws removed in step 3.
5. With the touchpanel in its normal position, make certain cable connections
are secure, put the plastic cover in position with the cables routed through
the rear opening. Secure the cover to the metal bracket using the four
# 4-40X 3/16-inch screws supplied.
SMK-6000 Assembly/Installation Procedure
To attach the SMK-6000 Swivel Mount Kit to the TPS-4500, -5000, or -6000
Touchpanel and install the assembly on a suitable mounting surface, refer to the
following illustrations and perform the associated procedures.
1. Prepare the mounting surface using the template provided with the kit. The
center hole for the swivel assembly should be 2.5-inches minimum;
2.6-inches maximum. Make certain to observe the “FRONT” position when
drilling the four holes for the swivel assembly standoff posts.
2. If necessary, to prevent errors when reconnecting, label and disconnect any
cables connected to the touchpanel.
3. If necessary, use the touchpanel position lock buttons to adjust the display
to the maximum (most vertical/upright) angle.
2
•
Hatchback and Swivel Mount Kits: HBK-6000 & SMK-6000
Installation Guide – DOC. 6111
