Software
Crestron
e-Control
®
(The Port field, the “Connect Using TCP” check box and the Device ID list
are reserved for future use.)
5. When you are satisfied with the IP settings, click
OK
to add the device to the
IP Table Editor.
6. Repeat this procedure for all the Ethernet devices in the program. When you
are ready to upload, click
Send IP Table to Control System
.
Whenever you send the IP Table to the control system, it will overwrite the previously
loaded IP Table.
Each Ethernet device in the SIMPL Windows program also has an IP Table called a
master list
, which sets the device’s IP ID and specifies the IP address (or FQDN) of
the control system(s) that will send it commands.
For Remote Ethernet Processing
(2-Series control systems operating in slave mode):
1. Set the IP ID. It must match the IP ID that is listed in the IP Table of the
master control system.
2. Enter the IP address or FQDN of the master control system.
3. Select
the
Set as Master
check box.
28
•
Crestron e-Control®
Reference Guide – DOC. 6052
