Reinstall the Shade Assembly
After the motor has been fully installed, roll the fabric
back onto the tube (if applicable), and then install the
shade assembly according to the mounting bracket’s
installation guide.
NOTE
: Limits need to be set after installation. Refer
to the Digital QMT Shade Motor Programming Guide
(Doc. 7437) for details.
Rotate the motor head until
the groove is visible through
the screw hole, and then
install the screws.
Motor Head
Motor assembly shown
through a cutout in the
roller tube.
Align the cusp with the screw hole and secure
with the provided screws
3. Rotate the motor head so that the groove in the
motor is shown through the second screw hole in
the roller tube.
4. Use a Phillips tip screwdriver and two supplied
screws to secure the motor head to the tube. Do
not overtighten.
2. Ensure that a cusp on the motor crown aligns with
the first screw hole in the roller tube. The cusp
should be no further than 1/4 in (7 mm) off center
of the screw hole. Ensure that the motor head is
flush with the roller tube.
2. Use a Phillips tip screwdriver and two supplied
screws to secure the motor crown to the tube. Do
not overtighten.
The product warranty can be found at
www.crestron.com/warranty.
The specific patents that cover Crestron products are listed at
patents.crestron.com.
Certain Crestron products contain open source software. For
specific information, please visit
www.crestron.com/opensource.
Crestron, the Crestron logo, and QMT are either trademarks
or registered trademarks of Crestron Electronics, Inc. in the
United States and/or other countries. Other trademarks,
registered trademarks, and trade names may be used in this
document to refer to either the entities claiming the marks
and names or their products. Crestron disclaims any
proprietary interest in the marks and names of others.
Crestron is not responsible for errors in typography or
photography.
Crestron Electronics, Inc.
Installation Guide
15 Volvo Drive
DOC. 7747C
Rockleigh, NJ 07647
(2043103)
Tel: 888.CRESTRON
03.16
Fax: 201.767.7576
Specifications subject to
www.crestron.com
change without notice.
This document was written by the Technical Publications
department at Crestron.
©2016 Crestron Electronics, Inc.
