Mount the Roller Shade Assembly (With an In-Line Coupler)
A coupled roller shade assembly consists of two or more roller shade
assemblies (bands) that interlock and secure each other. The bands are
supported using a coupler bracket. There is a motor band, an idler band,
and (optionally) one or more intermediate bands.
l
The motor band has a retractable pin on one side and the motor on the
other.
l
The intermediate band has a retractable pin on one side and a hole in
the other end that accepts a retractable pin.
l
The idler band has an idler pin on one side and a hole in the other end
that accepts a retractable pin.
The retractable pin traverses the bearing in the coupler bracket, which
provides support for the adjoining bands. The pin, when fully inserted into
the next band, provides control to the attached band.
The retractable pin is adjusted by rotating the ring marked EXTEND and
RETRACT. Use the spanner wrench to rotate the ring. The retractable pin
has detents that allow it to be adjusted to three predetermined positions.
Pin Positions
NOTES:
l
The pin is not fully extended until the white part of the pin is showing.
l
If the white part of the pin is showing and the two bands are not
engaged, the brackets are not installed at the dimensions entered in
the Crestron Design Tool (CDT).
l
During the installation of coupled shades, the fabric does not need to
be level. The fabric is leveled after installation. Leveling the fabric is
easier if all of the fabric is close in location.
Coupled Shade Installation Example
1. Use the spanner wrench to extend the pin on the motor band to the
half-extended position.
8
CSA-ARCH5 Series
Quick Start
Shade Motor Bracket Installation and Motor Programming
