Adjust the Roller Shade Assembly (CSA-ARCH5-BRKT-DUAL)
If the shade is still telescoping, it can be re-shimmed by applying a small
(1 in. x 1 in.) piece of tape to the end of the tube that the fabric should
move toward. Make sure that the tape is placed on the bare tube for best
results. The shade must be rolled all the way down past its lower limit. To
do this, place the shade motor into Limit Setup mode.
l
If the fabric is telescoping to the left, place the tape on the right side of
the tube.
l
If the fabric is telescoping to the right, place the tape on the left side of
the tube.
Swap the Idler and Motor Ends
The roller shade assembly can be mounted so that the idler and motor
ends are located in the ends of the tube opposite where they were when
received from the factory (i.e., the idler end is on the left and the motor
end is on the right). Swapping the idler and motor ends allows the roller
shade to still roll off of the proper side of the tube. This might be
necessary if the control or power wires were run to the wrong side of the
window. If this is necessary, the idler mount in the right bracket and
motor mount in the left bracket will need to be swapped. The left and right
mounting brackets remain on their intended side.
Swap the Bracket Hardware (CSA-ARCH5-BRKT and
CSA-ARCH5-BRKT-DUAL)
1. Using a Phillips or flat-blade screwdriver, remove the two standoffs
from the left-side bracket and save for reassembly.
16
CSA-ARCH5 Series
Quick Start
Shade Motor Bracket Installation and Motor Programming
