Crestron CNXRMC, Operation Manual

Page: 27 / 36

Crestron CNXRMC Room Solution Box
Operations Guide – DOC. 8162A Room Solution Box: CNXRMC
•
23
4. After setting the baud rate, cycle power to the RMC while continuing to
send a break command (Alt+K) until the screen display is similar to the
following.
Device Configuration Information
Uploading a SIMPL Windows Program
A control system source file has
the extension .smw. A compiled
SIMPL Windows file has the
extension .spz for a 2-Series
control system, .bin for CNX
generation, and .csz for CNX
generation with SIMPL+.
The SIMPL Windows file can be uploaded to the control system using SIMPL
Windows or via the Crestron Viewport.
Upload via SIMPL Windows
1. Start SIMPL Windows.
2. Select File | Open to view the “Open” window, navigate to the SIMPL
Window file (.smw), and click Open .
3. Select Project | Transfer Program .
Upload via Crestron Viewport
1. Verify that the procedure for “Communication Settings” that begins on
page 21 has been performed.
2. As shown after this step, select File Transfer | Send Program
(alternatively, press Alt+P ) from the Viewport menu.
File Transfer | Send Program Command
3. The “Send Program” window appears, as shown on the next page.
Click Browse , locate the compiled file (.spz) and click Open . This will
display the program's header information and enable one or both of the
What to Send check boxes. If the program does not contain any
SIMPL+ modules, only the SIMPL Program check box will be enabled.