Audio Switcher Bussing Kit
Crestron
CNX-ASBK
14. Repeat the previous two steps for all of the remaining PCB to PCB
cables.
15. Install the rack mounting ears and then the remaining cover screws to
11-inch/pounds.
Install the CNX-PAD8 Cover
INSTALL FOUR
(4) TOP SCREWS
INSTALL THREE
(3) SIDE SCREWS
INSTALL THREE
(3) SIDE SCREWS
IF NOT RACK
MOUNTED, INSTALL
THESE (3) SIDE
SCREWS ALSO
IF NOT RACK
MOUNTED, INSTALL
THESE (3) SIDE
SCREWS ALSO
16. If this procedure has been performed on only one CNX-PAD8, repeat
this procedure from step 7 for all of the CNX-PAD8s to be daisy-
chained.
17. If the back panels of the CNX-PAD8s will be accessible when mounted
in the rack, install the CNX-PAD8s. If the back panels will NOT be
accessible, hookup all cables before installing into rack.
NOTE:
DO NOT twist the cables during installation. The cables are custom
designed and will fit perfectly. If the cable does not fit correctly, switch the cable
ends from one CNX-PAD8 to another. DO NOT
force the connector onto pins.
18. Note the position of the connector keys and install the bussing cables
(6-inch, 12-conductor) from CNX-PAD8 to CNX-PAD8. Shown below
are the bussing cables for audio sources 1 – 2. Connect the cables as
required per custom installation.
Install the Bussing Cables
ELEC S INC. ROCKLEIGH, N.J. 07647
CRESTRON
2
RIGHT
LEFT
1
SOURCES
1 - 2
4
3
3 - 4
6
5
5 - 6
24
RIGHT
LEFT
G
8
7
7 - 8
ROOMS
3
2
1
7
6
5
4
Y
Z
G
CRESNET
24VDC
8
1A
12-PIN, 6-INCH CABLE TO CNX-PAD8
ABOVE, IF APPLICABLE
12-PIN, 6-INCH CABLE TO CNX-PAD8
BELOW, IF APPLICABLE
NOTE POSITION
OF CONNECTOR KEY
6
•
Audio Switcher Bussing Kit: CNX-ASBK
Operations & Installation Guide - DOC. 8143
