Crestron
CNMSX
Integrated Control System
CNMSX-PRO Rear Panel with Optional DPA Expansion Card and Rack Mounting Ears
Installed
CNMSX-AV Rear Panel with Optional DPA Expansion Card and Rack Mounting Ears Installed
Rubber feet are supplied and can be attached to the base of the unit for stability and to
prevent slippage when resting on a flat surface. The unit may also be rack mounted by
attaching metal flanges, also known as ears (supplied), to each end.
CNMSX Ports
A number of ports are provided on the front and rear panels of the CNMSX. Refer to
the description of each below.
CRESNET
CRESNET 4-Wire and 6-Pin Connectors
On the rear panel there are two network connectors: 4-wire and modular. The 4-pin
male connector (typical Crestron network port labeled 24 Y Z G) and 6-wire RJ-type
connector are used for expansion to Cresnet and SmarTouch peripherals. Depending
on the expansion slot load, there is a 50 W maximum load rating. The ports are wired
in parallel.
NOTE:
If using the 4-wire connector, review the latest revision of the network
interconnection drawing (Doc. 5411).
NOTE:
If using the modular connector, review the latest revision of the Network
Modular Cable Requirements (Doc. 5682). Most 4-conductor phone cables are wired
in a crisscross fashion and are not compatible with Crestron equipment.
The documents mentioned in the two preceeding notes can be obtained from the
Downloads page (CABLES and MANUAL Libraries) of the Crestron website
(
. Search for the CRESNET.PDF and MODULAR.PDF files.
Operations Guide - DOC. 8118B
Integrated Control System: CNMSX
•
3
