Crestron
CNIRHT-MM
30 Function Hand-Held IR Transmitter
Operations Guide - DOC. 8171 30 Function Hand-Held IR Transmitter: CNIRHT-MM
••
5
4. Release the “0” key and observe the LED of the CNIRHT-MM
blink
once
to indicate the keypad programming mode.
5. To set or display a Transmitter ID, perform the appropriate step
below.
5a. To
set
a Transmitter ID, press any button other than the “0”
key to establish a “1” key. To enter the desired Transmitter
ID code, use the “0” and “1” keys, enter any non-weighted
zeros, and enter the most significant bit first. For example, to
set the transmitter code to 12, press 0001 0010. After the
Transmitter ID code has been entered, it will be verified via
Morse code flashes of the LED. The unit then returns to the
normal operating mode.
5b. To
display
the current Transmitter ID, press the “0” key.
The Transmitter ID will be displayed via Morse code flashes
of the LED, most significant bit first. The unit returns to the
normal operating mode when the display is complete. To set
another Transmitter ID, repeat this procedure from step 2.
Set Transmitter ID via CNIDC and PC
To set the Transmitter ID of the CNIRHT-MM via the CNIDC and PC,
the PC must have the Crestron Viewport that is available in SIMPL
Windows or VT Pro-e. To set the Transmitter ID, perform the following
procedure.
1. Connect the 9-pin connector of the CNIDC to an available
COM port on the PC.
2. Position the CNIRHT-MM button-side down so the battery
compartment is accessible.
3. Remove the battery compartment cover.
4. Refer to the diagram on the next page. Place and hold the IR
probe of the CNIDC over the sensor (photo transistor) of the
CNIRHT-MM. The probe should be positioned between the
battery compartment and the sensor opening so that it
completely covers the sensor.
