CLW-SW, SWS, & SLVS(W/A/B)
Physical Description
Physical view of CLW-SLVS (clockwise from top; Top, Side,
and Front)
The -SW and -SWS switch contains two buttons (one
large, one small), a light emitting diode (LED), and a
three-position slider-switch as shown after this paragraph.
Line voltage connections are made at the rear of the
switch. Three Class 2 low voltage wires, located on the
front of the switch, provide a Cresnet connection to a
control system. The wires can be routed to the bottom of
the unit for placement outside of the wall box. The -SLVS
is similar to the -SW and -SWS but does not have the
slider-switch or the Class 2 low voltage wires.
CLW-SW/SWS shown in white
The -SW, -SWS, and -SLVS mount in a standard wallbox
and are covered using a decorative faceplate (not
included).
Physical view of CLW-SW/SWS (clockwise from top; Top,
Side, and Front)
Industry Compliance
This product is Listed to applicable UL Standards and
requirements by Underwriters Laboratories Inc.
Important Notes
Read before installation.
•
Codes: Install in accordance with all local and
national electrical codes.
Alternate wiring methods may be used for the
Class 2 wiring connection. The 2002 National
Electrical Code (Article 725-55) prohibits Class
2 conductors of the -SW, -SWS, and -SLVS to
occupy the same outlet box as the power
conductors. The exception is Part D of Section
725.55 of the 2002 National Electrical Code,
which allows a device’s power conductors to be
installed near (0.25 inch minimum spacing)
associated Class 2 conductors in the same outlet
box. Consult the 2002 National Electrical Code
Handbook and your local electrical inspector
before proceeding.
Do not use the supplied butt-splice connectors if
2
•
Stand Alone Wall Box Switch : CLW-SW, SWS, & SLVS
Installation Guide – DOC. 6134B