Crestron
CEN-SWPOE-24
24-Port Managed PoE Switch
Operations Guide – DOC. 7036C
24-Port Managed PoE Switch: CEN-SWPOE-24
•
9
Hardware Hookup
Make the necessary connections as called out in the illustration that follows this
paragraph. Refer to “Network Wiring” on page 6 before applying power. Apply
power after all connections have been made.
When making connections to the CEN-SWPOE-24, note the following:
•
Use Crestron power supplies for Crestron equipment.
•
The included cable cannot be extended.
Hardware Connections for the CEN-SWPOE-24 (Front View)
MGMT:
Connects to Computer to
Monitor Network Traffic
Hardware Connections for the CEN-SWPOE-24 (Rear View)
2 - 24:
To POE or Non-POE
Network Devices
GIGABIT UPLINK (25 – 26):
To Additional CEN -SWPOE-24
Units or Network Backbone
100 -240V~50/60Hz
4.8-2.0A:
Power from Line Voltage
Ground
NOTE:
Ensure the unit is properly grounded by connecting the chassis ground lug
to an earth ground (building steel).
NOTE:
To prevent overheating, do not operate this product in an area that exceeds
the environmental temperature range listed in the table of specifications.
NOTE:
Do not make any connections to the
NA
port on the rear of the switch. It is
the lowest left connector in the image shown above.