Mobile Cart Mount for 65” Display
Crestron
CCS-TS-6500-MCK
2
•
Mobile Cart Mount for 65” Display: CCS-TS-6500-MCK
Installation Guide – DOC. 7512A
Setup
Supplied Hardware
The hardware supplied with the CCS-TS-6500-MCK is listed in the following table.
Supplied Hardware for the CCS-TS-6500-MCK
DESCRIPTION
QUANTITY
Base
1
3” Casters (locking)
2
3” Casters (non-locking)
2
Support Tubes
2
Screw, M10 x 12 mm, Hex
4
Display Adapter
1
Screw, M8 x 10 mm, Set
6
Flat Washer, M10
4
Caster Wrench, 21 mm
1
Allen Wrench, M5
1
Allen Wrench, 5/32”
1
Installation
This section provides installation procedures for the base casters, support tubes and
display adapter. Be sure to review each procedure before starting.
WARNING:
The floor structure must be capable of supporting at least 250 lb (114
kg). If not, the floor structure must be reinforced. Proper installation procedure by a
qualified service technician, as outlined in the installation instructions, must be
followed. Failure to do so could result in serious personal injury.
WARNING:
Do not attach equipment weighing more than 75 lb (34 kg) above the
60” (~1.5 meter) marked line on the support poles. Doing so may cause the cart to tip
over, resulting in property damage and personal injury.
CAUTION:
Do not install on a structure that is prone to vibration, movement or
chance of impact. Doing so could result in damage to the display or damage to the
mounting surface.
CAUTION:
Do not install near heater, fireplace, direct sunlight, air conditioning or
any other source of heat. Doing so may result in damage to the display and could
increase the risk of fire.
CAUTION:
When used in conjunction with a wall mount used to support a flat
panel display, such as the CCS-TS-6500-WMK, be certain to attach the display
adapter to the center mounting position of the wall mount. It is important to
distribute the weight of the display evenly to avoid damage to the display or damage
to the wall mount.
