Crestron
CCS-TS-6500-MCK
Mobile Cart Mount for 65” Display
Installation Guide – DOC. 7512A
Mobile Cart Mount for 65” Display: CCS-TS-6500-MCK
•
3
Base Caster Installation
To install the base casters:
1.
Select the desired location for the CCS-TS-6500-MCK and place the base
on a flat surface.
NOTE:
Ensure the two locking casters are attached to the rear legs of the
cart.
2.
Insert each caster into the threaded mounting point located on the underside
of the base (refer to the following illustration). Turn each caster clockwise
to tighten. Ensure all four casters are tightened all the way until flush with
the base. Then tighten using the included 21 mm caster wrench.
Base Caster Installation
Locking Caster
Non-Locking Caster
Support Tube Installation
To install the support tubes:
1.
Place the base on a flat surface.
2.
Slide the support tubes over the mounting clamps on the cart (refer to the
following illustration).
NOTE:
To perform the following step, ensure the access holes located at
the ends of the support tubes line up with the set screw holes in the
mounting clamps. The upper holes are used for cable management once the
display has been mounted on the support tubes.
3.
Insert the set screws into each hole and tighten with the included M5 Allen
wrench.
