Crestron
C2N-IRGW-1G & C2N-IRGW-F
IR
Gateway
Connectors, Controls & Indicators
# CONNECTORS,
CONTROLS &
INDICATORS
DESCRIPTION
1 SETUP
BUTTON
Recessed miniature pushbutton for setup.
(Can be pressed with a paper clip.)
2
LED
(1 red) Indicates IR signal reception, Cresnet
network communication and setup/update.
LED location shown; not visible unless lit.
3 C2N-IRGW-1G:
NET
Four-position terminal block connector for
data and power. Connects to Cresnet control
network. An interface connector provided.
Pin 1 (24) Power
Pin 2 (Y)
Data
Pin 3 (Z)
Data
Pin 4 (G)
Ground
C2N-IRGW-F:
11” 4-wire pigtail
Red (24) Power
White (Y)
Data
Blue (Z) Data
Black (G)
Ground
Industry Compliance
As of the date of manufacture, the C2N-IRGW-1G and C2N-IRGW-F have been
tested and found to comply with specifications for CE marking and standards per
EMC and Radiocommunications Compliance Labelling.
NOTE:
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Operations & Installation Guide – DOC. 6468A
IR Gateway: C2N-IRGW-1G & C2N-IRGW-F
•
5
