Crestron C2N-DEMO, Reference Manual

Page: 6 / 24

Demonstration Case Crestron C2N-DEMO Lighting Case
Case Contents
The following table summarizes the products contained within the Lighting Case.
Contents of the Lighting Case
MODEL DESCRIPTION QTY
PAC2 2-Series Control Processor 1
C2ENET-2 Dual Port WAN/LAN Ethernet Card 1
CLX-1DIM8 1 – 20 AMP Feed, 8 – Controlled Circuits 1
CLT-1DIM8 Termination Block for the CLX-1DIM8 1
CAEN-2x1 Automation Cabinet with 2 Module Slots 1
The Lighting Case also ships with two cables:
•
Power Cable
•
Cross-over Cable
There are eight light bulbs representing loads at one end of the case. The loads are
identified in the following illustration.
Loads in the Lighting Case
MASTER
BATH
DOWNLIGHTS
MASTER
BEDROOM
FAMILY
ROOM
REAR
HALL
LIGHTS
KITCHEN
DOWNLIGHTS
DINING
CHANDELIER
GUEST
BEDROOM
DOWNLIGHTS
GUEST
BATHROOM
DOWNLIGHTS
Setup
Complete the following steps to setup your portable Lighting Case.
1. Apply Power
Open the case lid, simply plug the supplied power cord into the side of
the case (exterior face, near the large handle), and then into a standard
120 VAC wall receptacle.
NOTE : The following step describes the IP setup for a Windows

XP operating
system. The procedure may vary slightly for other systems.
2. Set IP Address
To setup the static IP address for your laptop, go to
Start | Settings |
Control Panel and double click Network Connections.
Right click on the icon for your Ethernet adapter and select
Properties .
Highlight the
Internet Protocol (TCP/IP) selection and click the
Properties button.
Select the radio button labeled
Use the following IP address: and enter
in the following information.
2
•
Crestron Demonstration Case: C2N-DEMO Lighting Case Reference Guide – DOC. 6282