2-Series Integrated Dual Bus Control System
Crestron
AV2 & PRO2
COMPUTER
FRONT PANEL
REAR PANEL
NET
24VDC 50W
24 Y Z G
These DB9F connectors (one on front panel and one on rear) are used when
programming with a PC. Each port is modem compatible. The modem and/or PC
program cable is not included.
NET
This connector (typical Crestron network port labeled 24 Y Z G) is used for
expansion to Cresnet devices. Depending on the expansion slot load, there is a 50 W
maximum load rating. Refer to "Network Wiring" on page 17 for details.
(Chassis Ground)
Use this chassis screw to connect the common ground of other system device(s)
common ground(s) to the AV2/PRO2.
100 240V
2.4A
Hz
60
50
100 – 240V ~ 2.4A 50/60 Hz (Power Supply)
This is an internal universal power supply connector. Use the supplied power cord to
connect to an AC outlet.
Indicators
The indicators provided on the front panel of the AV2/PRO2 integrated control
systems are described below.
PWR (Power)
This LED illuminates when the unit is connected to and receives power from an AC
outlet.
NET
This LED illuminates when the central processing unit is processing or
communicating with Cresnet devices.
ERR
This LED illuminates when an error condition is detected. This may be the result of
hardware or software failure, missing/wrong card placed in a slot, or a programming
error. To decipher content, examine the message available from the menu function
buttons or through Viewport.
NOTE:
The LAN LEDs are active only if a single port or dual port Ethernet card
(which is field installed) occupies the Z-BUS slot.
LNK A, LNK B (LAN)
These LEDs illuminate when the Ethernet card has established a valid Ethernet
connection.
ACT A, ACT B (LAN)
These LEDs illuminate when there is communication (activity) at the respective port
on the Ethernet card.
NOTE:
The LEDs described after this note appear only on the PRO2 configuration.
8
•
Integrated Dual Bus Control System: AV2 & PRO2
Operations Guide - DOC. 5957A
