Genesis Ultrasonic Generator-IM-1.1
Ultrasonic Cleaning
Rev 1.1
, February 21, 2013
1-1
1.
Ultrasonic Cleaning
1.1
Introduction
Operating the generator with any portion of the safety
systems or procedures bypassed can result in severe system
damage and human injury.
This manual provides product descriptions, operating instructions,
maintenance recommendations and troubleshooting procedures. Due to our
constant efforts to build a better product, changes are made from time to time
to our generators. These changes may not be reflected in this instruction
manual. Therefore, when ordering replacement parts, please tell us the
generator model number, serial number, and voltage, which may be found on a
label at the rear of the generator chassis. You should also refer to the circuit
board part number (with revision notation) and serial number, which are
printed on the circuit board.
Serial Numbers:
When communicating with Crest about transducerized tanks,
please refer to the serial numbers of the tank and generator(s) shown on the
metal identification plates. Most serial numbers will have the following type of
numeric configuration: XXXX-T-YYYY (
example
).
If you have purchased Crest ultrasonic cleaning equipment which utilizes cable
lengths greater than 20 feet between the generator(s) and transducers, you will
need a
capacitance compensation package.
If such a package is not part of your
current order, please contact the Crest Sales Department (609 883-4000) or your
local Crest representative for a quotation.
