ODC CLASSIC XL
TM
OUTDOOR DISCOVERY CRAFT
TM
Your ODC Outdoor Discovery Craft
TM
is designed to give you many years of service.
Please follow inflation instructions and warnings carefully.
IF YOU EVER HAVE ANY QUESTIONS OR PROBLEMS WITH YOUR ODC CLASSIC XL
TM
PLEASE DO NOT RE-
TURN IT TO THE DEALER YOU BOUGHT IT FROM. PLEASE CONTACT THE CREEK COMPANY
DIRECTLY TOLL FREE AT 1-800-843-8454. WE ARE OPEN M-F 9AM-5PM MOUNTAIN TIME. OR CONTACT US VIA
E-MAIL AT [email protected].
HIN is located on square tubing of seat support frame member and on right main frame member (See Figure 1)
Warning:
Please read and follow carefully.
1. Always wear a US Coast Guard approved personal flotation device when in your ODC CLASSIC XL
TM
.
2. Never float alone.
3. Always check your ODC CLASSIC XL
TM
Air Bladders, outer skin and stitching for possible damage before you use your craft.
4. Never use your craft if you suspect the Air Bladders, outer skin or stitching has been damaged.
5. Never overinflate your ODC CLASSIC XL
TM
.
6. Never use your ODC CLASSIC XL
TM
without the Pontoons fully inflated.
7. Your ODC CLASSIC XL
TM
is not designed for use in salt water.
CARE AND MAINTENANCE:
1. If your Pontoon Bladder is losing air, please check that Valve Assembly and Top Valve Cap are fully seated. Reseat valve
assembly and repeat pontoon inflation instructions.
2. Do not store your ODC CLASSIC
TM
in direct sunlight.
3. If you are leaving your ODC CLASSIC XL
TM
out in the sun for any amount of time, be aware that the heat can increase the
pressure inside the Pontoons to a dangerous level. Let some of the air out of the pontoons if the craft will be out of the water in the
sun for any length of time, or if it is stored in a vehicle, etc.
4. A gain in altitude will increase the pressure in the Pontoons also. If you are taking your inflated ODC CLASSIC XL
TM
from a
low elevation to a high elevation, be sure to let some of the air out of it.
5. For short term storage, we recommend you let some air out of your pontoons.
6. For long term storage, we recommend you make sure your ODC CLASSIC XL
TM
is completely dry, deflated and stored out
of the sunlight in a cool dry area.. Do not store your wet ODC CLASSIC XL
TM
in freezing temperatures as this may result in
Frame and other component damage.
7. Repairing Bladder, use enclosed patch kit. Identify puncture. Fully deflate Bladder. Clean and dry area around puncture. Apply
glue to puncture area and patch using applicator straw. Press patch over puncture area. Allow 24 hours to dry, before inflating.
8. Note: Metal parts may rust and are not covered under warranty.
Accessories are available for your ODC CLASSIC XL
TM
.
Ask for them where you bought your ODC SUPERSPORT XR 1™, or visit the Creek Company Store at www.CreekCompany.com
The Creek Company Ltd. , PO Box 773892, Steamboat Springs, CO 80477
email: [email protected] • Made in China
Specifications and other details subject to change without notice. All Creek Company
products are guaranteed against defects in material and workmanship for the
life of theproduct to the original owner.
This does not cover damage due to misuse or normal wear and tear.
