3 of 4
LPN00467X0003A0_B
CLEANING LENS
STEP 1:
Locate the end cap with the arrow marks on it, indicating that
the end cap is removable.
STEP 2:
Grab the lens section next to the end cap and pull lens and
end cap together downward gently. See
Figure 6.
STEP 3:
Disengage the other end of the lens from the other end cap.
Once lens is removed perform cleaning. See
Figure 7.
STEP 4:
After cleaning is complete insert lens back into fixed end
cap. Push the removable end cap upward into the housing
and using a gentle rocking motion engage the end cap to
retention clip. Check lens for any visible gap between the lens
and luminaire. If necessary push lens upward at gap location
to seal magnetic foam to luminaire. See
Figure 8.
FCC NOTICE
To comply with the FCC RF exposure compliance
requirements, this device and its antenna must not be co-
located or operating to conjunction with any other antenna or
transmitter.
This equipment should be installed and operated with
minimum distance 5cm between the radiator & your body.
FCC COMPLIANCE STATEMENT
CAUTION: Changes or modifications not expressly approved
could void your authority to use this equipment.
This device complies with Part 15 of the FCC Rules. Operation
to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation
This device has been tested and found to comply with the
limits for a Class A digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when
the device is operated in a commercial environment. This
device generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this device in a residential
area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own
expense.
The LED in the front of this device operates within Risk Group
1 levels per IEC 62471.
INDUSTRY CANADA STATEMENT
This device complies with Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device. In addition, this device complies with ICES-003 of the
Industry Canada (IC) Regulations.
Le présent appareil est conforme aux CNR d’Industrie
Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes
: (1) l’appareil ne doit pas produire de brouillage, et (2)
l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible
d’en compromettre le fonctionnement.
6
7
End Cap
Arrow Marks
Arrow Marked
End Cap
8
Fixed End Cap
