2 of 4
LPN00238X0001A1_E
TO INSTALL:
LUMINAIRE INSTALLATION
NOTE:
Multiple luminaire installation can consist of Non-Emergency
Driver LS luminaires with Emergency Driver LS luminaire. An additional
2 -wire power feed is needed for the emergency driver luminaire. Refer to
non emergency LS luminaire installation sheet for electrical wiring.
STEP 1:
Remove the lens/ frame assembly from the housing by pulling up on the
three pull tabs. After releasing the tabs, release latches along length
of luminaire by pressing on designated areas of base and pull top lens
frame assembly away from base. Pull tabs can be discarded once lens/
frame assembly is removed. If the lens/frame needs to be removed in the
future, once pull tabs have been discarded, then use a non-marring tool
or by hand and release the rivet-catch on each end of the luminaire. After
releasing rivet-catches, (See
Figure 1, 2,
and to the righ
NOTE:
The lens and metal lens frame is a single assembly and does not
come apart. DO NOT attempt to remove the lens from the metal lens
frame.
• LS4:
Press in the center and on each end (22" away from the
center) of the base. Total of 3 designated areas to press.
• LS8:
Press in the center and every 23" away from the center, two
per each end. Total of 5 designated areas to press.
2
Plug
Luminaire Base
Emergency Driver
Lens and Metal Lens Frame
Assembly
Rivet- Catch
Latch
Lens and Metal Lens Frame
Assembly
Squeeze the Base
Latch
Latch
Pull lens frame assembly
from base
(3) Pull Tabs
1
