- 4 -
3
INSTALLATION OF THE RADIATOR
Turn the carton upside down and open the carton from
the bottom. Remove the feet from the polystyrene
corner supports, and the plinth and accessories bag from
the polystyrene centre support.
2
Remove the clip containing the probe from the bottom
of the radiator. See Picture below.
1
(Do not discard the clip or remove probe from clip)
.
3
Fit the feet to the radiator by engaging the flanges on
the top of the foot with the slots in the base of the
radiator
1
. Push the foot towards the back of the radiator
until it is fully engaged
2
.
Clip the probe onto the open side of the adjacent foot.
3
ASSEMBLY
2
2
4
The radiator is packed with the direct acting mains cable
clipped to the underside of the radiator ensuring it is secure
during transit. The off peak mains cable will be secured with
cable ties. Prior to installing the radiator, unclip the direct acting
mains cable (do not remove or discard these clips).
NOTE: If the off peak mains connection is required to be
made on the right hand side of the radiator, the pre-wired
cable must be passed behind the feet and secured using
the clips on the base of the radiator. For ease of access
this should be done while the radiator is still upside down
in the carton. Similarly when the direct acting mains cable
is ready to be connected (See Section 23), if the connection
is required to be made on the left hand side of the radiator
the cable must be routed behind the feet. DO NOT clip the
direct acting mains cable at this stage (See Section 23).
The cable clips are already fitted at the factory to allow
both mains cables to be attached, if required.
1
3
3
Summary of Contents for Eco-Response ER300
Page 3: ...3 Circuit Diagram...
