Assembly
© Copyright 2005, Creative Playthings
Williamsburg
19687-100 rev s (10-17)
Page 18
ASSeMbly inStruCtionS
SteP 27 - Slide:
Position the slide onto the slide mount (K) through the open-
ing prepared in earlier steps. Center the slide in the opening
and pull it tight to the platform until it stops against the edge
of the front Platform end (W). make sure and that the holes
in the slide are over the slide mount (K).
Check that the slide extends out perpendicular from the play
set.
drill 5/16" holes through the slide, slide mount (K) and Plat-
form boards using the holes in the slide as a guide. Fasten
the slide using one 1/4 x 3" Truss head bolt and one 1/4"
Weld nut for each hole.
K
SteP 26 - Slide Mount:
Place the slide mount (K) tight against the front Platform
end (W), centered on the opening left for the slide. The bev-
eled edge of the slide mount should face the inside of the
gym. secure the slide mount to the Platform boards using
four #10 x 2-1/2" Flat head Wood screws.
drive the screws until the heads are flush with the top of the
slide mount. do not over-tighten; over-tightening may cause
the points of the screws to protrude through the bottom of
the Platform boards.
K
SteP 25 - Hand grips:
Fasten the hand grips (J) to the entrance Wall slats (u)
using two 1/4 x 1" hex bolt assemblies each.
The deluxe hand grip must be oriented as shown in the
illustration. installing the grip upside-down could cause
injury, according to asTm guidelines.
u
J
