Assembly
© Copyright 2005, Creative Playthings
Williamsburg
19687-100 rev s (10-17)
Page 12
ASSeMbly inStruCtionS
SteP 7 - inside Stringers
locate the two inside stringers (g). The inside stringers (g)
are installed between the Platform ends (W). attach each
inside stringer (g) using two 5/16 x 4" lag screws and Flat
Washers as shown. make sure the outside stringers (h)
and inside stringers (g) are aligned across the top edge.
SteP 8 - Safety rail:
locate the safety rail (a); fasten it to the Corner Posts (F)
on the side a swing Frame is to be positioned using two 5/16
x 3" lag screws with 5/16" Flat Washers as shown.
SteP 9 - Angle braces:
Fasten an angle brace (b) to each end of both Platform
sides (Q) using four 5/16 x 2-1/2" hex bolt assemblies. do
not tighten these bolts yet. The angle braces (b) should be
fastened so that the angled end is flat against the Corner
Post nearest to it.
Fasten an angle brace (b) to each end of the Platform ends
(W) using four 5/16 x 2-1/2" hex bolt assemblies. do not
tighten these bolts yet. The angle braces (b) should be
fastened so that the angled end is flat against the nearest
Corner Post.
g
W
h
a
b
Q
Q
W
b
W
