© Copyright 2004, Creative Playthings, Printed in U.S.A.
PINNACLE ROCK WALL
19652-400 Rev F (05-20)
Page 6
ASSEMBLY INSTRUCTIONS
#10 x 2-1/2" T25 Deck Screw
1/4 x 4"
Hex Bolt
STEP 9 — Drill Rope Hole:
Set the top Rope board in place, at the top of the Rock Wall.
Mark the Wall or Platform Support in line with the large hole
in the Top Rope Board. Remove the top Rope Board. Drill a
1" hole through the Support.
STEP 10 — Fasten Top Rope Board:
Use two 1/4 x 4" Hex Bolts, two 1/4" Lock Washers, two 8mm
Flat Washers to fasten the Top Rope Board to the Angled
Rails. Thread the Bolts through the Top Rope Board, the
Angled Rails and into the Weld Nuts inserted in step 4.
Finish securing the Top Rope Board using four #10 x 2-1/2"
T25 Deck Screws.
Drill a 1/8" diameter pilot hole for each
screw.
Hex Bolt
Hex Bolt
Lock Washer
Lock Washer
Flat Washer
Flat Washer
Weld
Weld
Nut
Nut
STEP 11 — Fasten Climbing Rocks:
Fasten a Climbing Rock (K) to each pair of holes in the Rock
Boards. Use 1/4 x 1-1/2" Hex Bolts, 1/4" Lock Washers,
8mm. Flat Washers and 1/4" Weld Nuts. Do not over-tighten
the fasteners. The bolt must sit completely into the Climbing
Rock, and not protrude more than a 1/8" past the end of the
Weld Nut.
Replace any protruding bolts as they can be a hazard to
users.
