PINNACLE ROCK WALL
19652-400 Rev F (05-20)
© Copyright 2004, Creative Playthings, Printed in U.S.A.
Page 5
ASSEMBLY INSTRUCTIONS
STEP 6 — Remove Wall Slats:
(Skybox installation only)
The Pinnacle Rock Wall must be fastened to the rear of your
Skybox. Create one opening, 22"-24" wide, in the rear wall of
your Skybox by removing three Wall Slats (see illustration).
Save the removed Wall Slats in case they are needed for
repair or replacement.
22" - 24"
opening
STEP 7— Attach Brackets:
Attach the Access Ladder Brackets to the Angled Rails of the
Rock Climber Assembly using the holes provided. Use One
5/16 x 2-1/2" Hex Bolt, one Lock Washer, one Flat Washer,
and one Weld Nut to fasten each Access Ladder Bracket.
Note: The Access Ladder Bracket can be mounted to the
inside or outside of the Angled Rails.
Support
drill holes
STEP 8 — Attach Rock Climber:
Lean the Rock Climber Assembly into place against the
Support in the position desired. Position the Access Ladder
Brackets with one surface flat against the surface of the Plat-
form Support. Mark the position of the holes in the Brackets
onto the Support.
If the Access Ladder Bracket is to be fastened to the Support
only, drill a hole at the mark using a 3/8" diameter drill bit.
Any Wall Slats that may interfere should be removed. Fasten
each Access Ladder Bracket to the Support using one 5/16"
x 1-1/2" Hex Bolt , one Lock Washer, one Flat Washer, and
one Weld Nut.
If the Wall Support is backed by a Corner Post or any other
solid structure, drill a 1/4" diameter hole 2" deep. Fasten with
a 5/16 x 2-1/2" Lag Screw and Flat Washer.
Note: When mounting to a Skybox, fasten the Brackets to the
Platform Support.
