Page 5
©
Copyright 2006, Creative Playthings. Printed in U.S.A.
19718-300 Rev C (05-20)
7 Ft. Swing Beam
ASSEMBLY INSTRUCTIONS
STEP 6 - Install Swing Beam
NOTE:
This step requires at least two
people to complete.
Fasten the Beam Retainer (F), the Swing
Beam Assembly (A) and L-Brace (G) to the
second hole on the Swing Mount using one
3/8 x 7-1/2" Hex Bolt Assembly, as shown.
Secure the L-Brace to the Swing Beam
using one 3/8 x 4" Hex Bolt Assembly (The
Weld Nut should be on the front of the Swing
Beam), as shown.
In order to assure that the Hex Bolts fully
engage with the Weld Nut, the Hex Bolts
used in this step are slightly longer than
necessary. Please use additional Flat
Washers if the end of the Hex Bolt extends
more than 1/8" beyond the Weld Nut.
STEP 5 – Install Angle Brace & Legs
Fasten the Angle Brace (B) and two Leg Assemblies (D) to the T-Bracket Assembly using one 5/8 x 10" Hex Bolt, two 5/8"
Flat Washer and one 5/8" Nylock Nut. Do not fully tighten the Hex Bolt Assembly. Secure the Angle Brace (B) to the Swing
Beam Assembly using one 3/8 x 4" Lag Screw and one 3/8" Flat Washer.
B
D
A
Hex Bolt
3/8 x 7-1/2"
Use Additional
Flat Washers
Hex Bolt
3/8 x 4"
F
A
A
G
