Assembly
MODELS PS10CLATL & PTCLATL
19772-100 Rev L (03-19)
© Copyright 2010, Creative Playthings. Printed in U.S.A.
Page 7
ASSEMBLY INSTRUCTIONS
STEP 3 – End Ladders:
Slide a Rung Collar (K) over each end
of all 18" Rungs (G).
Assemble one Right End Ladders Rail
(C) and one Left End Ladder Rail with
the Rung Assemblies in the same man-
ner as the Top Ladder. See illustration
at right for orientation of rails.
Use one #10 x 2-1/2" Self-drilling Screw
to secure each end of each Rung. Make
sure that the collar of each Rung As-
sembly is tight against the End Ladder
Rail before inserting the screws into the
holes and fastening them with a drill fit-
ted with a #2 Phillips bit.
Repeat with the other End Ladder.
STEP 4 – Base Rail & Side Supports:
Flip the End Ladder so that the screws holding the Rungs
are face down.
Attach the End Ladder Base (B) to the outside of the End
Ladder as shown at point #1 using two 1/4 x 4-1/2" Hex Bolt
Assemblies.
Attach the Side Supports (A) to the End Ladder Base as
shown at point #2 using two 1/4 x 2-1/2" Hex Bolt Assem-
blies.
Align each Side Support so that the angled end fits flush with
the side of an End Ladder Rail. Attach each Side Support as
shown at point #3 using one 1/4 x 2-1/4" Hex Bolt Assembly.
Repeat with the other End Ladder.
STEP 5 – Top Ladder to End Ladders:
This kit may contain either flat 6" Triangle Braces or flanged
Triangle Braces (shown). The flanged braces come in left
and right versions. Install each brace so the flange fits under
the Top Ladder Rail.
Attach one Triangle Brace (L) to the inside of the End Ladder
Rail at (1) using one 5/16 x 1-1/2" Hex Bolt Assembly*.
Align the Triangle Brace, Top Ladder and End Ladder Rails at
point (2). Fasten using one 5/16 x 2-1/2" Hex Bolt Assembly.
Attach the Triangle Brace to the Top Ladder at (3) using one
5/16 x 1-1/2" Hex Bolt Assembly. If the plate has a flange,
fasten the flange to the under side of the Top Ladder Rail at
(4) using two #10 x 3/4" Pan Head Screws.
Repeat on the other Top Ladder Rail and at the other end of
the set.
Flip the End Ladder
before this step.
B
A
E
C
K
G
1
2
3
* A Hex Bolt As-
sembly consists of
one Hex Bolt, one
Lock Washer, one
Flat Washer and
one Weld Nut.
1
2
3
4
