Assembly
NEWBURY
19963-100 Rev C (05-20)
© Copyright 2015, Creative Playthings
Page 15
ASSEMBLY INSTRUCTIONS
STEP 17 – Rope Bottom Support:
Align the large hole in the Rope Bottom Support (K) with the
back of the large hole in the Rope Board. Fasten the Rope
Bottom Support to the Rope, Spacer and Rock Boards using
six #8 x 1-5/8" Screws.
STEP 19 – Mount Access Ladder:
Loosely fasten two Access Brackets to the inside of the Ac-
cess Ladder Rails using one 5/16" x 1-1/2" Hex Bolt Assem-
bly each, as shown.
Lean the Access Ladder in place. Center the ladder on
the side of the gym.
Mark the position of the holes in the Access Brack-
ets on the Platform Support. Check for obstructions
behind the board before drilling 3/8" diameter holes
through the support.
Fasten the Access Ladder Brackets to the platform
using 5/16 x 1-1/2" Hex Bolt Assemblies. Tighten all
hardware.
STEP 18 – Assemble Access Ladder:
Slide the Ladder Steps (A) into the slots cut into
the Left and Right Ladder Rails (V & W), as shown.
Make sure the lower corners on the sides of the
steps fit even with the face of the Rails. Secure
each Step using four #8 x 2-1/2" Screws through
the holes provided.
Fasten the Ladder Slat (L) to the back of the Lad-
der Rails using four #8 x 2" Screws. Use a 1/8"
diameter drill to create a pilot hole for each screw.
Leave a gap of 2" between the top of the Step
and the bottom of the Ladder Slat.
A
V
L
W
K
Lower corner of
step flush with rail.
2"
