Assembly
NEWBURY
19963-100 Rev C (05-20)
© Copyright 2015, Creative Playthings
Page 13
ASSEMBLY INSTRUCTIONS
STEP 13 – End Tent Pipes & Tent:
Slide one tent Pipe (H) through the hem at one end of the
Tent (G).
Loosen the fasteners that secure the left end of the Front
Tent Support. Fit one end of the Tent Pipe into the large
socket in the Back Tent Support. Fit the other end of
the Pipe into the socket in the Front Tent Support.
Retighten the fasteners.
Drape the Tent over the center Tent Pipe. Slide
the final Tent Pipe through the hem at the
other end of the Tent.
Loosen the fasteners that secure the right
end of the Front Tent Support. Fit one end
of the Tent Pipe into the socket in the Back
Tent Support. Fit the other end of the Pipe into
the socket in the Front Tent Support. Retighten
the fasteners.
Straighten the Tent.
Use a 1/8" diameter drill to bore a pilot hole up
through the bottom of a Tent Support and one
wall of the steel Tent Pipe, as shown. Secure the
Tent Pipe to the Tent Support using one #8 x 2-1/2" Screw.
Repeat with the three other ends of the Tent Pipes.
Drill a 1/8" diameter pilot hole through one side of a Tent
Post and one wall of the center Tent Pipe. Secure the Tent
Pipe to the Tent Post using one #8 x 1-5/8" Screw. Repeat
with the other Tent Post.
STEP 12 – Tent Posts & Center Pipe:
Fasten one Tent Post Assembly (E) to the back End Tent
Support using two 5/16 x 3" Hex Bolt Assemblies, as shown.
Slide one Tent Pipe (H) into the large hole at the top of the
Tent Post Assembly. Slide the Other Tent Post Assembly
over the opposite end of the pipe.
Fasten the Tent Post Assembly to the front End Tent Support
using two 5/16 x 3" Hex Bolt Assemblies. Make sure each
Tent Post is plumb before tightening the fasteners.
H
H
G
E
E
Loosen
fasteners
Front Tent
Support
If the Hex Bolt protrudes beyond the
Weld Nut use EXTRA Flat Washers
under the Lock Washer.
