© Copyright 2005, Creative Playthings
LEXINGTON WITH WOOD ROOF
19686-300 Rev Q (09-20)
Page 18
ASSEMBLY INSTRUCTIONS
STEP 29 — Slide:
Place the slide in the opening resting on the slide mount,
projecting straight out from the tower. Your slide may have
stops that indicate placement. If so, pull the slide tight
against the platform support. If your slide does not have
stops, check the underside of the slide to judge how far to
overlap the slide mount. Make sure the holes in the slide are
over the slide mount.
Make sure the slide extends out perpendicular from the play
set.
Drill 5/16" holes through the slide, slide mount and platform
Boards using the indents in the slide as a guide. Fasten the
slide using one 1/4 x 3" Truss Head Bolt and one 1/4" Weld
Nut for each hole.
K
J
T
K
STEP 27 — Hand Grips:
Fasten the Hand Grips (J) to the entrance wall slats using
two 1/4 x 1" hex bolt assemblies each.
The hand grips must be oriented as shown in the illustration,
with the big loop at the bottom.
STEP 28 — Slide Mount:
Place the Slide Mount (K) tight against the front platform
end, centered on the opening left for the slide. Face the bev-
eled edge of the slide mount toward the inside of the gym.
Secure the slide mount to the platform boards using four #10
x 2-1/2" screws.
Drive the screws until the heads are flush with the top of the
slide mount. Do not over-tighten; over-tightening may cause
the points of the screws to protrude through the bottom of
the platform boards.
