Filament
Feed port
Put the filament on the filament holder, pull the filament out, and insert them from the top inlet.
Filament loading and unloading
Nozzle preheating
Step �
Home
Tools menu
Heating menu
Preheating of heating plate
Nozzle 1 preheating
Nozzle 2 preheating
Step �
Step �
�
Tools submenu
Loading and unloading submenu
Manual submenu
Axis test
Home
Click the Tools menu → click the preheat icon → choose preheat the heating plate or nozzle.
Example: Click the up arrow of print head � to preheat the print head. Click the up or down arrow multiple times to adjust
the specified temperature. If you print PLA consumables, it can be adjusted to ��� ° C.
Tools submenu
This operation is required when the nozzle is preheated to ��� ° C. In the tools submenu, click the filament icon enter the
submenu for loading and unloading filament. Click the down arrow marked with E� to perform pre-extrusion of the filament.
If it is observed that consumables are normally extruded from the nozzle, the extruder test steps are completed. Click the
back icon to go to the home page.
Note: unless the filament run out of or need to print another color, there is no need to repeat the above three steps for each
subsequent printing, just start the machine and choose the file to print.
Click the manual icon to enter the manual submenu, select �mm or ��mm, and then click the arrow corresponding to XYZ to
perform the axis movement test. Click the Home icon to return home. In addition, this function can also be used to make it
easier to remove the model by lowering the Z-axis platform when the model is inconvenient.
